Electronic Anti-Scale System
green alternative technology to water softeners
Water is more than an H2O equation. Putting aside a host of many other impurities that may be found in your consumption water supply; there are essential dissolved minerals in your water that are critical for biological functions for you, plants, and other biological lifeforms. Removing these mineral from your water (i.e. calcium, magnesium) will start to alter your water chemistry and eventually jeopardize your health.
The Vulcan Electronic Anti-Scale System is NOT a water filter; it does NOT remove minerals, it temporarily changes (1-7 days) the molecular construction of minerals so they do not bond to surfaces. All the benefits of sofftened water but without the environmental influence, that slimy feel of soft water, and without using salt or other consumables.
Wherever Water Flows, Vulcan Supports:
- Cooling Towers
- Boilers
- Hot Water Tanks
- Heat Exchangers
- Chillers
- Water Pressure
- Pressure Valves
- Circulating Pumps
- Large Water Softeners
- Swimming Pools
- Irrigation Systems
- Drinking Water Filters
- Restroom Facilities
- Showering Facilities
- Grease Traps
- Ice Machines
The Vulcan mineral descaler has eliminated our water softener, along with the required salt and water consumption. We have also observed a drastic reduction in our dishwasher soap usage. 
Wherever your company occupies space.
Vulcan has been descaling all types of businesses for decades
Wrap it around.
Installation is very easy but if you need onsite installation support, reach out to us.
- Put the two cable ties through the fixing holes at the bottom of the electronic device. Place the device onto the pipe. Use the cable ties to secure the device to the pipe.
- Connect one of the impulse bands to the device and use another cable tie to fasten it onto the pipe.
- Wind the impulse bands around the pipe producing a coil. Make sure you wind the band tightly to the pipe and place the windings close to each other.
- Latch the end of the impulse band to the pipe using another cable tie. Now repeat the procedure with the second impulse band.
- First plug the connector into the upper right in-jack of the device and then connect the power supply unit with an electrical outlet.
- The red pilot lights will illuminate as soon as the device starts to operate. Vulcan works from now on and maintenance-free.
- Protect the electronic unit, the impulse bands and the power supply against humidity and water.
- Only use the provided electronic switching adaptor.
- Do not cut the impulse bands or the 36 V power cord of the power supply unit.
- Do not remove the end caps or the impulse band insulation.
- The operating temperature of Vulcan ranges from -13°F to 122°F.
- Temperature peaks on heating element surfaces should not exceed ~203°F.
- Clean the device with water only.
Installation Examples:
- For optimal water treatment, Vulcan is best installed near the water meter or at the main water supply.
- The impulse band windings can be placed on the left side, on the right side or underneath the electronic device. Leave a safe distance of 1 inch or more between the bands.
- Vulcan can be installed vertically, horizontally or at any other angle. If there is no space available on the pipe the electronic block can also be wall-mounted.
- In case of limited space the windings can be placed partly on the main pipe and partly on the distributor pipe.
These various installations setups are possible because the treatment impulses extend over 9-16 feet on either sides of the impulse bands along the water pipe length.
Cooling Towers
Chemically treating cooling towers to remove mineral scale does not make a lot of financial sense since as little as 1 mm of scale has been linked to an increase of 15% in energy demands. If you use the Vulcan hard water mineral descaler it will continuously remove and prevent mineral scale from forming without requiring labor, resins, filtration or any other consumables (other than 2.5 watts of energy)
Boilers
From small single use hot water tanks to enormous industrial boilers, the Vulcan descaler has a proven success rate from over 70 countries at preventing and removing mineral scale in all type of equipment. This greentech not only improves energy efficiency but also increases equipment longevity and reduces maintenance labor costs while supporting sustainability interests.
Heat Plate Exchanger
⅛ inch thickness on heating elements can result in 20%-25% efficiency loss. It is completely unrealistic to pull apart your buildings heat exchangers every day and manually clean surfaces. Incorporating the Vulcan descaling tech into your building will mean that every second that water is flowing through pipelines and into equipment, surfaces are constantly being cleaned and scale formation prevented.
Chillers
Speak to facility maintenance companies or a building’s maintenance staff and scale deposits are a constant bane on equipment maintenance. It is common knowledge that scaling/ limescale fouling increases energy costs by reducing the heat transfer surface on both cooling (chiller) and heating (boiler) systems. You could continue to use harmful chemical treatment or outrageously priced water softening systems (that kinda work) or install the Vulcan descaler that constantly work with zero effort.
From pressure valves to your entire building.
As water comes into your building to the furthers end point, the Vulcan technology can be positioned in strategic locations to support your family run restaurant, tropical resort location, to industrial manufacturing facility. Contact us and we’ll working with you and your building personnel to recommend installation models and locations: 412-848-5058 |
Pump.
Keep water moving without causing excessing wear-and-tear on pumping equipment. Progressive nations around the world (example: United Arab Emirates) who need to maximize water efficiency have incorporated this environmental tech to prevent and remove mineral scale and rust while increasing the efficiency of the water irrigation equipment.
