Electronic Anti-Scale System
green alternative technology to water softeners
Water is more than an H2O equation. Putting aside a host of many other impurities that may be found in your consumption water supply; there are essential dissolved minerals in your water that are critical for biological functions for you, plants, and other biological lifeforms. Removing these mineral from your water (i.e. calcium, magnesium) will start to alter your water chemistry and eventually jeopardize your health.
The Vulcan Electronic Anti-Scale System is NOT a water filter; it does NOT remove minerals, it temporarily changes (1-7 days) the molecular construction of minerals so they do not bond to surfaces. All the benefits of sofftened water but without the environmental influence, that slimy feel of soft water, and without using salt or other consumables.
wherever water flows, Vulcan supports:
Cooling TowersBoilers
Hot Water Tanks
Heat Exchangers
Chillers
Water Pressure
Pressure Valves
Circulating Pumps
Large Water Softeners
Swimming Pools
Irrigation Systems
Drinking Water Filters
Restroom Facilities
Showering Facilities
Grease Traps
Ice Machines
The Vulcan mineral descaler has eliminated our water softener, along with the required salt and water consumption. We have also observed a drastic reduction in our dishwasher soap usage. 
Wherever your company occupies space.
Vulcan has been descaling large scale equipment for decades
Wrap it around.
Installation is very easy but if you need onsite sales and installation reach out to a local provider.
1. Put the two cable ties through the fixing holes at the bottom of the electronic device. Now place the device onto the pipe. Use the cable ties to latch the device to the pipe.
2. Connect one of the impulse bands to the device and use another cable tie to latch it to the pipe.
3. Wind the impulse bands around the pipe producing a coil. Make sure you wind the band tightly to the pipe and place the windings close to each other.
4. Latch the end of the impulse band to the pipe using another cable tie. Now repeat the procedure with the second impulse band. 5. First plug the connector into the upper right in-jack of the device and then connect the power supply unit with an electrical outlet.
6. The red pilot lights will illuminate as soon as the device starts to operate. Vulcan works from now on maintenance-free
Use the provided electronic switching adaptor only.
Do not remove the end caps or the impulse band insulation.
Temperature peaks on heating element surfaces should not exceed ~203°F.
Clean the device with water only.
Installation Examples:
1. For optimal water treatment Vulcan is best installed near the water meter or at the main water supply.
2. The impulse band windings can be placed on the left side, on the right side or underneath the electronic device. Leave a safe distance of at least ½“ (1 cm) between the bands.
3. Vulcan can be installed vertically, horizontally or at any other angle. If there is no space available on the pipe the electronic block can also be wall-mounted.
4. In case of limited space the windings can be placed partly on the main pipe and partly on the distributor pipe. All these different installations are possible because the treatment impulses extend over several meters to either side of the pipes.
Cooling Towers
info-
Boilers
info.
Heat Plate Exchanger
residential and commercial
Chillers
info.
Pressure Valves.
info.
Pump.
info.
Solar water heating without your horror experience.
The Vulcan descaler gets limescale off internal vacuum tubes, out of collectors and heat exchangers, and keeps your system from over-heating; without you sweating it or the concern of correct circulation dosing descaling acids.
