Electronic Anti-Scale System
green alternative technology to water softeners
Water is more than an H2O equation. Putting aside a host of many other impurities that may be found in your consumption water supply; there are essential dissolved minerals in your water that are critical for biological functions for you, plants, and other biological lifeforms. Removing these mineral from your water (i.e. calcium, magnesium) will start to alter your water chemistry and eventually jeopardize your health.
The Vulcan Electronic Anti-Scale System is NOT a water filter; it does NOT remove minerals, it temporarily changes (1-7 days) the molecular construction of minerals so they do not bond to surfaces. All the benefits of softened water but without the environmental influence, that slimy feel of soft water, and without using salt or other consumables.
Wherever Water Flows, Vulcan Supports:
- Hot Water Heater
- Dishwasher
- Washing Machine
- Water Pressure
- Solar Water Heater
- Plant Growth and Health
- General Household Cleaning
- Swimming Pools
- Jacuzzis/ Hot Tubs
- Water Pumps
- Irrigation Systems
- Garden Sprinklers
- Water Filtration Equipment
The Vulcan mineral descaler has eliminated our water softener, along with the required salt and water consumption. We have also observed a drastic reduction in our dishwasher soap usage. 
Wherever you call home.
Vulcan has been descaling all types of homes for decades
Wrap it around.
Installation is very easy but if you need onsite installation support, reach out to us.
- Put the two cable ties through the fixing holes at the bottom of the electronic device. Place the device onto the pipe. Use the cable ties to secure the device to the pipe.
- Connect one of the impulse bands to the device and use another cable tie to fasten it onto the pipe.
- Wind the impulse bands around the pipe producing a coil. Make sure you wind the band tightly to the pipe and place the windings close to each other.
- Latch the end of the impulse band to the pipe using another cable tie. Now repeat the procedure with the second impulse band.
- First plug the connector into the upper right in-jack of the device and then connect the power supply unit with an electrical outlet.
- The red pilot lights will illuminate as soon as the device starts to operate. Vulcan works from now on and maintenance-free.
- Protect the electronic unit, the impulse bands and the power supply against humidity and water.
- Only use the provided electronic switching adaptor.
- Do not cut the impulse bands or the 36 V power cord of the power supply unit.
- Do not remove the end caps or the impulse band insulation.
- The operating temperature of Vulcan ranges from -13°F to 122°F.
- Temperature peaks on heating element surfaces should not exceed ~203°F.
- Clean the device with water only.
Installation Examples:
- For optimal water treatment, Vulcan is best installed near the water meter or at the main water supply.
- The impulse band windings can be placed on the left side, on the right side or underneath the electronic device. Leave a safe distance of 1 inch or more between the bands.
- Vulcan can be installed vertically, horizontally or at any other angle. If there is no space available on the pipe the electronic block can also be wall-mounted.
- In case of limited space the windings can be placed partly on the main pipe and partly on the distributor pipe.
These various installations setups are possible because the treatment impulses extend over 9-16 feet on either sides of the impulse bands along the water pipe length.
Traditional water softeners are an eco-issue
A typical antiquated water softening system will use some form of ion-exchange (salt, resins, etc.) to attract calcium, magnesium and other minerals out of your water supply and thereby lowering the concentration of minerals, and softening the water. This old technology has been reinvented and repackaged several times but each reinvention uses the same principals, ultimately increasing the cost of ownership, negatively affecting the environment and changing your water chemistry resulting in long-term damage.
Better washing machine efficiency
Commercial Laundry Service Company: "Without the Vulcan Descaler Treatment System we would be replacing our hot water system every two years at a cost of more than $10,000."
The Vulcan V5000 model is a great solution for residential homes of all sizes.
Extended lifespan with cleaner dishes
The Vulcan descaling technology is designed to install on your main water pipe that comes into your home. From that point the treated water flows through your home, in and out of appliances (like your dishwasher) to remove existing mineral scale and prevent new scale from occurring. Your dishes and glass wear will be cleaner while using less soap and extending the longevity of your dishwasher.
Enjoy your pool more than your kids.
Go beyond your home and connect Vulcan descalers to your pool’s filtration and mechanical equipment to prevent scaling. Circulation pumps last longer, sand filter require less changing, cut down on chlorine tablets, control bacteria growth and PH levels, and for an overall cleaner pool and surfaces with less effort.
Get back to loving your hot tub.
Connect the Vulcan to your hot tub and spa equipment and you’ll find any excuse to use it now because your past limescale build-up issues seemingly take care of themselves; any excess scale simply wipes off.
