A 3 month grease trap test using the Vulcan electronic mineral descaler.
The injection molding machine have scaled badly for years, so it was always difficult to clean the pipe, especially the heat exchanger of the mold temperature controller.
Vulcan Electronic mineral descalers solve scaling problems in the cooling towers of a molding factory.
The vulcan electronic hard water descaler removes built-up mineral scaling to improve heat exchange efficiency.
Before installing the Vulcan anti-scale solution the scale was very thick and hard in the heat exchanger tubes.
A 4 year field test of the Vulcan electronic descaler was conducted at a Mall’s cooling towers in Indonesia. During the 4 years no system maintenance was required and the system was not treated with chemicals. Mall administration and maintenance report the prevention of rust in their iron pipes has been an added benefit.
Suzhou Weixin Electronics (MFlex a DSBJ company) uses the Vulcan mineral descalers in their manufacturing facilities to prevent corrosion in their air compressor equipment, to capitalize on energy efficiencies and eliminate prior descaling maintenance.
The system Vulcan 5000 is an economic alternative to expensive heat exchangers, i.e. closed circulations of coolant with treated water. These heat exchangers cost about 5,000€. The device Vulcan 5000 has been used on a trial basis since the end of March to treat the coolant of our gas laser. On the 12th of December the company coherent GMBH checked the laser tubes for lime deposits on the ceramic surface. No lime deposits were detected, therefore, it is in all a positive result.
We have been using your Vulcan-Impulse-Technology for over a year with great success. Six months following an intensive purification and the installation of your Vulcan technology, only very few deposits in the warming zone and none at all in the cooling zone could be found.
Page 3 of 3
